TM 9-4940-568-20
3-68
3-16. WIRING HARNESS MAINTENANCE (CONT).
f.
Type II Connector Repair or Replacement.
NOTE
Connector is removed by gently
prying up on clip and pulling on
connector.
All Type II connectors are
repaired the same way. Number
of wires in connector may vary.
Both halves of the connector are
repaired the same way.
(1)
Disconnect connector (34).
(2)
Unlatch and open two secondary locks (35)
on connector (34).
Tip if removal tool is very sharp.
Use caution when using tool.
Failure to comply may result in
injury to personnel.
(3)
Insert removal tool into cavity (36) on
connector (34) until seated.
(4)
Pull wire (37) back through connector (34)
and remove tool.
NOTE
Perform Step (5) only if old
terminal is still attached to wire.
Make cut directly behind
damaged terminal.
(5)
Cut terminal (38) and wire seal (39) from
wire (37). Discard terminal (38) and seal
(39).
(6)
Insert wire (37) through new wire seal (39).
31
30
32
35
29
35
34
27
28
34
36
37
38
39
31
27
34
WEATHERPACK
REMOVAL TOOL
