TM 9-4940-568-20
3-69
(7)
Strip end of wire (37) leaving 1/4 in. (6.4
mm) of bare wire.
(8)
Insert new terminal (38) in locating hole of
crimping tool using proper hole according to
the gage of wire (37).
(9)
Slide seal (39) down to end of insulation
(40) on wire (37).
NOTE
Wire and seal should be
positioned so larger wings of
terminal will crimp around seal
and smaller wings will crimp
around exposed bare wire.
(10)
Position wire (37) on terminal (38).
(11)
Press handles of crimp tool together until
ratchet releases and crimp is complete.
(12)
Push new terminal (38) and wire (37)
through connector (34) until seated.
(13)
Close two secondary locks (35) on
connector (34).
(14)
Connect connector (34).
37
39
39
40
37
38
34
36
37
38
39
34
35
34
35
CRIMPING TOOL
