TM 9-2330-389-14&P
Section VIII. BRAKE SYSTEM MAINTENANCE
Paragraph Title
Paragraph No.
Page No.
Service Brake Maintenance........................................................................... 4-23 ....................................... 4-21
Hydraulic Wheel Cylinder Replacement ......................................................... 4-24 ....................................... 4-27
Hydraulic Lines, Hoses, and Fittings Maintenance........................................... 4-25 ........................................ 4-27
Parking Brake Cable Replacement ................................................................ 4-26 ........................................ 4-31
Bleeding Hydraulic Brake System .................................................................. 4-27 ........................................ 4-21
4-23.
SERVICE BRAKE MAINTENANCE.
This Task Covers:
a.
Disassembly
b.
Cleaning and Inspection
c.
Assembly
d.
Minor Adjustment
Initial Setup:
Equipment Conditions:
Materials/Parts:
Brakedrum removed (para 4-32).
Dry cleaning solvent (Item 6, Appendix E)
Tire assembly removed (para 4-28)
Rags (Item 5, Appendix E)
Brake lining clamp, 11686281
Tools/Test Equipment:
Spring washer, 935-0004
Common #1 tool set
General mechanic's tool kit
a.
DISASSEMBLY
WARNING
DO NOT handle brakeshoes, brakedrums, or other brake components unless area
has been properly cleaned. There may be asbestos dust on these components,
which can be dangerous if you touch it or breathe it. Wear an approved filter mask
and gloves. Never use compressed air or a dry brush to clean brake components.
Dust may be removed using an industrial-type vacuum cleaner. Clean dust or mud
away from brake components with water and a wet, soft brush or cloth. Failure to
follow this warning may result in serious illness or death to personnel.
NOTE
Use this procedure for both the left and the right inner and outer service brake.
Right inner service brake is shown.
4-21
