TM 9-2330-359-14&P
NOTE
If your brake press cannot bend 10 gauge steel, fold-
over channel fabrication may be required by outside
contractor.
1. Form fold-over channel.
Flat Pattern
Fold-over channel
Material: 10GA X 17-7/8” X 90-3/4”
LG Hot Rolled Commercial Quality
Steel that meets ASTM A569
5-22 Change 1
*Measurement is approximate.
Measure width of trailer bulkhead at
interior dimension to side racks before
fabrication to obtain best fit. If
fold-over channel is too wide It will not
fold down between side racks.
