TM 5-4930-244-14
(7)
Lift air-receiver tank (3) from skid weldment (12).
(8)
Remove four washers (16) and four vibration isolators (17) from skid weldment (12).
c.
Installation.
(1)
Install four washers (16) and four vibration isolators (17) into skid weldment (12).
(2)
Install new air-receiver tank (3) on skid weldment (12) aligning holes in air-receiver tank (3) with holes in
vibration Isolators (17) and holes in skid weldment (12).
(3)
Install four vibration isolator washers (15), four washers (14), and four hex head-cap screws (13) through
holes in air-receiver tank (3) and skid weldment (12).
(4)
From bottom of skid weldment (12) install four washers (11) and four new self-locking nuts (10) onto four
hex head-cap screws (13). Tighten.
(5)
Install hex bushing (9) and attached fittings into air-receiver tank (3).
(6)
Install swivel adapter (6) and hose assembly (7) into hex bushing (8).
(7)
Install hex nipple (4) and hose assembly (5) into side of air-receiver tank (3).
(8)
Install elbow, push-in fitting (2) into air-receiver tank (3). Slide nylon hose (1) onto elbow, push-in fitting (2).
5-30
