TM 5-4930-244-14
(2)
Install the assembled piston assembly (21) and low pressure connecting rod (22) into the crankcase (5).
(3)
Slide the low pressure connecting rod (22) onto the crankshaft.
(4)
Align the holes in the lower gasket (33) with holes in the crankcase (5).
(5)
Align the holes in the cylinder (25) with lower gasket (33) and crankcase (5).
(6)
Install four bolts (18) through the flange on the cylinder (25), lower gasket (33) into the crankcase (5)
Tighten.
(7)
Install new valve gasket assembly (27) into cylinder (25) Align the holes in head gasket (28) with holes in
the cylinder (25).
(8)
Align low pressure cylinder head (24) holes with holes in head gasket (28) and cylinder (25).
(9)
Install six bolts (23) through low pressure cylinder head (24), head gasket (28) and cylinder (25). Tighten.
(10)
Install air cleaner assembly (19) and elbow (34) into the low pressure cylinder head assembly (20).
(11)
Reassemble the high pressure piston (14) and connecting rod (4) as follows.
(a)
Install bushing (16) into high pressure connecting rod (4).
(b)
Install piston rings (15) in piston (14).
(c)
Install piston pin (13) through piston (14) and connecting rod (4). Secure with two snap rings (12).
(12)
Install the assembled piston assembly (3) and high pressure connecting rod (4) into the crankcase (5).
(13)
Slide the high pressure connecting rod (4) onto the crankshaft.
(14)
Align the holes in the lower gasket (17) with holes in the crankcase (5).
(15)
Align the holes in the lower gasket (17) with holes in the crankcase (5).
(16)
Install four bolts (1) through the flange on the cylinder (8), lower gasket (17) into the crankcase (5).
Tighten.
(17)
Install new valve gasket assembly (10) into cylinder (8).
(18)
Align the holes in head gasket (11) with holes in the cylinder (8).
(19)
Align high pressure cylinder head (7) holes with holes in head gasket (11) and cylinder (8).
(20)
Install five bolts (6) through high pressure cylinder head (7), head gasket (11) and cylinder (8). Tighten.
(21)
Using a suitable bearing driver press the bearing (23, Figure 5-8) and oil seal (22) onto the crankshaft (4).
5-27
