TM 5-4930-244-14
(22)
Align gasket (24) up with holes in bearing retainer (7) and crankcase (17).
(23)
Slide the bearing retainer (7) and crankshaft (4) onto connecting rods and crankcase (17).
(24)
Install six bolts (21) through bearing retainer (7) and gasket (24) into crankcase (17).
(25)
Align gasket (9) up with holes in bearing retainer (7) and seal retainer (8).
(26)
Install four bolts (6) through seal retainer (8) and gasket (9) into bearing retainer (7).
(27)
Align holes in round disk (20) with holes in crankshaft (4).
(28)
Install four bolts (19) through round disk (20) into crankshaft (4). Tighten.
(29)
Install woodruff key (10) into crankshaft (4).
(30)
Install vent tube fitting (12) into bearing retainer (7).
(31)
Install crankshaft vent tube (11) onto vent tube fitting (12) and elbow on low pressure cylinder head.
(32)
Position intercooler (5) behind flywheel (3) and slide flywheel (3) onto crankshaft (4).
(33)
Install washer (2) and nut (1) securing flywheel (3) to crankshaft (4).
(34)
Align lower gasket (18) holes up with holes in crankcase (17), and holes in crankcase cover (15).
(35)
Install four bolts through crankcase cover (15) and lower gasket (18) into crankcase (17).
(36)
Install sight gauge (25) and washer (26) into lower portion of crankcase (17).
(37)
Install oil level gauge (13) and gasket (14) into crankcase cover (15).
NOTE
Run the air pump long enough to warm up Shut down the air pump and retorque
cylinder head bolts (6 and 23, Figure 5-9) to 30 ft. lbs.
5-28
