TM 5-4930-244-14
Equipment Condition
Unit shut down and cool.
Enclosure Removed (para. 4-13).
Alternator and Guard Removed (para. 4-31).
Compressor Drive Belts and Guard Removed (para. 4-31).
Control Panel Removed (para. 4-30).
Diesel Engine Removed (para. 4-39).
Fuel Tank Drained and Removed (para. 4-21).
Air Cleaner Assembly Removed (para. 4-39.).
Heater Plug Removed (para. 4-39).
Starter Motor Removed (para. 4-39).
Oil Filter Assembly Removed (para. 4-39)
Lubricating Oil Pipe Removed (para. 4-39).
Exhaust System Removed (para. 4-39).
Rope Start Assembly Removed (para. 4-39).
Clutch Removed (para. 4-40).
Drain Diesel Engine Oil (para. 4-39).
Personnel Required
2
a.
Fuel Pipe-Pump and Leak-Off Pipe.
(1)
Removal. (Refer to Figure 5-11).
(a)
Remove pump-to-injector fuel pipe (1) from fuel injector (2) and fuel pump (3) by removing fuel pipe
nuts (4).
(b)
Remove bolt (5), two washers (6), swivel union (7) from top of fuel injector (2). Remove pipe
assembly tube (8) from swivel union (7).
(2)
Repair.
Inspect pipe assemblies for damage, cracks, distortion and other damage. Replace parts as needed.
(3)
Installation.
(a)
Install swivel union plug (5), two washers (6), and swivel union (7), into top of fuel injector (2).
(b)
Slide pipe assembly tube (8) onto swivel union (7).
(c)
Install pump-to-injector fuel pipe (1) into fuel injector (2) and fuel pump (3) using pipe nuts (4).
5-33
