TM 5-3825-230-14&P
(3)
Rotate flywheel clockwise 2.40 to 2.59 in. (61 to
66 mm), fuel should squirt out of tube fitting (4)
when measured distance is passing timing mark
(5) on engine.
NOTE
If fuel does not appear, refer to para
4-36 and bleed the fuel system again.
(4)
If timing is not correct refer to para 5-33 and
add or remove injector pump shims.
(a)
If fuel squirts before timing marks meet,
add one injector pump shim and recheck.
Repeat step if fuel still appears before
timing marks meet.
(b)
If fuel squirts after timing marks meet, remove one injector pump shim and recheck. Repeat step if fuel
still appears after timing marks meet.
(5)
Refer to para 5-33 to install pump.
(6)
Repeat previous procedures until timing is correct.
(7)
Install tube fitting (4) and pipe (3) using a 17 mm open end wrench.
NOTE
Follow-on maintenance:
•
Connect battery cables (para 4-73)
•
Install flywheel housing (para 4-53)
•
Install rear panel (para 4-98)
•
Install water tank (para 4-121)
END OF TASK
5-73
