TM 5-3825-230-14&P
(6)
Remove two tube fittings (1) using a 19 mm open end wrench.
(7)
Compress springs (9) on push rod tubes (10).
(8)
Install metal shims (15) and injector pump (3).
(9)
Install washer (14) and nut (13). Tighten to 66 lb-in (7.4 N•m) using a torque wrench and 13 mm open end
wrench.
(10)
Install three washers (12) and screws (11). Tighten to 66 lb-in (7.4 N•m) using a torque wrench and 6 mm hex
head wrench.
(11)
Install tube fittings (1) using a 19 mm open in wrench.
NOTE
Follow-on maintenance:
•
Install injector pump fuel lines (para
•
Install intake manifold (para 4-32)
4-44 and 4-45)
•
Check injector timing (para 5-32)
•
Install governor control lever assembly
(para 5-29)
•
Install engine (para 4-24)
END OF TASK
5-77
