TM 5-3805-296-23-2
0147
Table 1. Right Rear Turn/Stop Light Does Not Operate Continued.
0147
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Disconnect connector J-C8
Right Rear Turn/Stop Light
(WP 0012, Figure 100)
Does Not Operate
from connector W-C1
Continued
(WP 0012, Figure 99).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to step 4.
between connector J-C8
Resistance Greater Than 5.0 Ohms
terminal 28 (WP 0012, Figure 100)
Replace chassis wiring harness
and connector J-C6 terminal 23
(WP 0305).
(WP 0012, Figure 141).
Proceed to Test Step 17.
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 7.
between connector J-C6
Resistance Greater Than 5.0 Ohms
terminal 12 (WP 0012, Figure 141)
Replace chassis wiring harness
and ground.
(WP 0305).
Proceed to Test Step 17.
Test Step 7. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove upper plenum from ROPS
(WP 0504).
2. Disconnect connector P-C1
(WP 0012, Figure 253) connector
W-C7 (WP 0012, Figure 252).
3. Using digital multimeter (WP 0540)
Resistance 5.0 Ohms or Less
and assistance, measure
Proceed to Test Step 8.
resistance between
Resistance Greater Than 5.0 Ohms
connector W-C7 terminal 46
Replace main cab wiring harness
(WP 0012, Figure 252) and
(WP 0505).
connector W-C1 terminal 28
Proceed to Test Step 17.
(WP 0012, Figure 99).
Test Step 8. Test Dash Wiring
Harness for High Resistance or
Open.
1. Disconnect connector P-C2
(WP 0012, Figure 265)
from connector N-C1
(WP 0012, Figure 264).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 9.
between connector P-C2
Resistance Greater Than 5.0 Ohms
terminal 2 (WP 0012, Figure 265)
Replace dash wiring harness
and connector P-C1 terminal 46
(WP 0510).
(WP 0012, Figure 253).
Proceed to Test Step 17.
0147-6