TM 5-3805-296-23-2
0147
Table 1. Right Rear Turn/Stop Light Does Not Operate Continued.
0147
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector AE-C1
Right Rear Turn/Stop Light
(WP 0012, Figure 144)
Does Not Operate
from connector E-C2
Continued
(WP 0012, Figure 143).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 5.
between connector AE-C1
Resistance Greater Than 5.0 Ohms
terminal 13 and terminal 31
Remove jumper wire from connector
(WP 0012, Figure 144).
AE-C4 terminal 6 and terminal 9
(WP 0012, Figure 174).
Replace draft frame and bowl side
wiring harness (WP 0348).
Proceed to Test Step 17.
Test Step 5. Test Hitch Wiring
Harness for High Resistance or
Open.
1. Lower left frame access plate
(WP 0376).
2. Remove jumper wire from
connector AE-C4 terminal 6 and
terminal 9 (WP 0012, Figure 174).
3. Connect jumper wire between
connector E-C2 terminal 13
and terminal 31
(WP 0012, Figure 143).
4. Disconnect connector E-C3
(WP 0012, Figure 142)
from connector J-C6
(WP 0012, Figure 141).
5. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 6.
between connector E-C3
Resistance Greater Than 5.0 Ohms
terminal 12 and terminal 23
Remove jumper wire from connector
(WP 0012, Figure 142).
E-C2 terminal 13 and terminal 31
(WP 0012, Figure 143).
Replace hitch wiring harness
(WP 0401).
Proceed to Test Step 17.
Test Step 6. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
connector E-C2 terminal 13
and terminal 31
(WP 0012, Figure 143).
0147-5