TM 5-3805-296-23-2
0147
Table 1. Right Rear Turn/Stop Light Does Not Operate Continued.
0147
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
8. Using digital multimeter
Right Rear Turn/Stop Light
Voltage 18 to 26 V Have assistant
(WP 0540), test for voltage
Does Not Operate
release brakes.
between connector AH-C6
Continued
Turn mode switch on military light
(WP 0012, Figure 177)
switch to OFF position
and connector AH-C9
(TM 5-3805-296-10).
(WP 0012, Figure 180) while
Turn ignition switch and battery
assistant applies brakes
disconnect switch to OFF position
(TM 5-3805-296-10).
(TM 5-3805-296-10).
Replace right rear blackout lamp
(WP 0352).
Proceed to Test Step 17.
Voltage Less Than 18 V Have
assistant release brakes.
Turn mode switch on military light
switch to OFF position
(TM 5-3805-296-10).
Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
Proceed to Test Step 3.
Test Step 3. Test Tail Lights/Backup
Alarm Wiring Harness for High
Resistance or Open.
1. Disconnect connector AH-C1
(WP 0012, Figure 325) from
connector AE-C4
(WP 0012, Figure 174).
2. Connect jumper wire between
connector AH-C1 terminal 6 and
terminal 9 (WP 0012, Figure 325).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 4.
between connector AH-C6
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 177)
Remove jumper wire from connector
and connector AH-C9
AH-C1 terminal 6 and terminal 9
(WP 0012, Figure 180).
(WP 0012, Figure 325).
Replace tail lights/backup alarm wiring
harness (WP 0351).
Proceed to Test Step 17.
Test Step 4. Test Draft Frame and
Bowl Side Wiring Harness for High
Resistance or Open.
1. Remove jumper wire from
connector AH-C1 terminal 6 and
terminal 9 (WP 0012, Figure 325).
2. Connect jumper wire between
connector AE-C4 terminal 6 and
terminal 9 (WP 0012, Figure 174).
0147-4
