TM 5-3805-296-23-2
0093
Table 1. 0096 Fuel Level Sensor Diagnostic Code.
0093
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
0096-03 Fuel Level Sensor
Voltage Above Normal
Always inspect harness connectors that are involved in the circuit. Poor
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Monitoring System Detects Above Normal Voltage on Fuel Level Sensor
Circuit 447.
POSSIBLE CAUSE
Push Frame Wiring Harness High Resistance, Open, or Shorted.
Draft Frame and Bowl Side Wiring Harness High Resistance, Open, or
Shorted.
Hitch Wiring Harness High Resistance, Open, or Shorted.
Chassis Wiring Harness High Resistance, Open, or Shorted.
Main Cab Wiring Harness High Resistance, Open, or Shorted.
Dash Wiring Harness High Resistance, Open, or Shorted.
Fuel Level Sender.
Tractor Operator Monitor.
Test Step 1. Test Voltage to Fuel
Level Sender.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector AF-C6
(WP 0012, Figure 172) from fuel
level sender connector
(WP 0012, Figure 171).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
4. Using digital multimeter
Voltage Greater Than 6.5 V Proceed
(WP 0540), test for voltage
to Test Step 2.
between connector AF-C6
Voltage 6.5 V or Less Proceed to
terminal 1 and terminal 2
Test Step 8.
(WP 0012, Figure 172).
