TM 5-3805-296-23-2
0082
Table 1. 1294 Ejector Return Indicator Diagnostic Codes Continued.
082
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
1294-05 Ejector Return
Lamp Current Below Normal
Always inspect harness connectors that are involved in the circuit. Poor
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Abnormally Low Current on Ejector Return
Lamp Circuit R748 During Lamp Test or Ejector Return Operation.
POSSIBLE CAUSE
Ejector Return LED Open.
Dash Wiring Harness High Resistance or Open.
Main Cab Wiring Harness High Resistance or Open.
Transmission/Chassis ECM.
0082-5