TM 5-3805-296-23-2
0081
Table 1. 1293 Cushion Hitch Push Switch Diagnostic Codes Continued.
081
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Switch Status Changes Each Time
2. On MSD, select applicable status
1293-04 Cushion Hitch
Jumper Wire is Connected and
group (Figure 4, Item 1). View
Switch Voltage Below
Disconnected Replace implement
Cushion Hitch Switch status
Normal Continued
control joystick (WP 0503).
(Figure 4, Item 2) while performing
Proceed to Test Step 8.
the following:
Switch Status Fails to Change Each
a. Connect jumper wire between
Time Jumper Wire is Connected and
terminal 5 and terminal 8 of
Disconnected Replace transmission/
connector CG-C14
chassis ECM (WP 0495).
(WP 0012, Figure 302).
Proceed to Test Step 8.
b. Remove jumper wire from
terminal 5 and terminal 8
of connector CG-C14
(WP 0012, Figure 302).
c.
Connect jumper wire between
terminal 5 and terminal 9
of connector CG-C14
(WP 0012, Figure 302).
d. Remove jumper wire from
terminal 5 and terminal 9
of connector CG-C14
(WP 0012, Figure 302).
Figure 4. Cushion Hitch Switch Status.
0081