TM 5-3805-296-23-2
0081
Table 1. 1293 Cushion Hitch Push Switch Diagnostic Codes Continued.
081
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using digital multimeter
1293-04 Cushion Hitch
Continuity Replace main cab wiring
(WP 0540), test for continuity
Switch Voltage Below
harness (WP 0505).
between connector W-C12
Normal Continued
Proceed to Test Step 8.
terminal 56 (WP 0012, Figure 88)
No Continuity Proceed to step 6.
and all terminals in connector
W-C13 (WP 0012, Figure 89).
6. Using digital multimeter
Continuity Replace main cab wiring
(WP 0540), test for continuity
harness (WP 0505).
between connector W-C12
Proceed to Test Step 8.
terminal 56 (WP 0012, Figure 88)
No Continuity Replace transmission/
and ground.
chassis ECM (WP 0495).
Proceed to Test Step 8.
Test Step 8. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
1293-4 Cushion Hitch Switch Voltage
diagnostic codes (WP 0008).
Below Normal Becomes Inactive
Troubleshooting complete. Proceed to
step 4.
1293-4 Cushion Hitch Switch Voltage
Below Normal Remains Active
Repeat troubleshooting from the
beginning.
4. Install right trim panels on ROPS
(WP 0494).
NOTE
1293-07 Cushion Hitch
Switch Mechanical System
Always inspect harness connectors that are involved in the circuit. Poor
Not Responding
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Cushion Hitch Switch is Stuck in Closed
Position.
POSSIBLE CAUSE
Implement Control Joystick.
0081-15