TM 5-3805-296-23-2
0078
Table 1. 1283 Ejector Control Position Sensor Diagnostic Codes Continued.
-
078
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
1283-13 Ejector Lever
Position Sensor Out of
Perform this test only if condition is active.
Calibration
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Joystick Duty Cycle Values Out of Range.
POSSIBLE CAUSE
Implement Control Joystick Requires Calibration.
Test Step 1. Perform Joystick Ejector
Lever Sensor Calibration.
CAUTION
Failure to hold joystick in proper position during calibration will create
invalid test results.
Perform joystick ejector lever sensor
Calibration Successful
calibration (WP 0173).
Troubleshooting complete.
Active Diagnostic Code Present
Diagnose and repair active code
(WP 0005).
Calibration Value Too Low Replace
implement control joystick (WP 0503).
Calibration Value Too Large
Replace implement control joystick
(WP 0503).
END OF WORK PACKAGE
0078-15/(16 blank)