TM 5-3805-296-23-2
0078
Table 1. 1283 Ejector Control Position Sensor Diagnostic Codes Continued.
-
078
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 6. Inspect Fuse Panel
1283-08 Ejector Lever
Wiring Harness.
Position Sensor Abnormal
1. Turn ignition switch and battery
Signal Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
3. Inspect connector CG-C1
Connector CG-C1 Damaged
(WP 0012, Figure 283) for damage
Replace fuse panel wiring harness
IAW Electrical General
(WP 0515).
Maintenance Procedures
Proceed to Test Step 11.
(WP 0540).
No problem found - Proceed to Test
Step 7.
Test Step 7. Inspect Main Cab Wiring
Harness.
1. Disconnect connector W-C12
(WP 0012, Figure 88) from
transmission/chassis ECM.
2. Inspect connector W-C8
Connector W-C8 or W-C12 Damaged
(WP 0012, Figure 282), connector
Replace main cab wiring harness
W-C12 (WP 0012, Figure 88), and
(WP 0505).
and transmission/chassis ECM for
Proceed to Test Step 11.
damage IAW Electrical General
Transmission/Chassis ECM
Maintenance Procedures
Damaged Replace transmission/
(WP 0540).
chassis ECM (WP 0495).
Proceed to Test Step 11.
No Problem Found - Proceed to Test
Step 8.
Test Step 8. Verify if Code is Still
Active.
1. Connect connector W-C12
(WP 0012, Figure 88) to
transmission/chassis ECM.
2. Connect connector CG-C1
(WP 0012, Figure 283)
to connector W-C8
(WP 0012, Figure 282).
3. Connect connector CG-C15
(WP 0012, Figure 301) to
implement control joystick
connector (WP 0012, Figure 300).
0078-12
