TM 5-3805-296-23-2
0078
Table 1. 1283 Ejector Control Position Sensor Diagnostic Codes Continued.
-
078
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Turn battery disconnect switch to
1283-08 Ejector Lever
ON position and start engine
Position Sensor Abnormal
(TM 5-3805-296-10). Operate
Signal Continued
Joystick (ejector control)
through full range of motion
(TM 5-3805-296-10).
5. At MSD, check for active
1283-8 Ejector Lever Position Sensor
Abnormal Signal Becomes Inactive
diagnostic code 1283-8 Ejector
Lever Position Sensor Abnormal
Troubleshooting complete. Proceed to
Signal (WP 0008).
step 6.
1283-8 Ejector Lever Position Sensor
Abnormal Signal Remains Active
Replace implement control joystick (WP
0503).
Proceed to Test Step 9.
6. Install right trim panels on ROPS
(WP 0494).
Test Step 9. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch to
ON position and start engine
(TM 5-3805-296-10). Operate
Joystick (ejector control)
through full range of motion
(TM 5-3805-296-10).
3. At MSD, check for active
1283-8 Ejector Lever Position Sensor
diagnostic codes (WP 0008).
Abnormal Signal Becomes Inactive
Troubleshooting complete. Proceed to
step 4.
1283-8 Ejector Lever Position Sensor
Abnormal Signal Remains Active
Replace transmission/chassis ECM
(WP 0495).
Proceed to Test Step 11.
4. Install right trim panels on ROPS
(WP 0494).
0078-13