TM 5-3805-296-23-2
0077
Table 1. 1282 Apron Control Position Sensor Diagnostic Codes Continued.
077
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Inspect Implement
1282-08 Apron Lever
Control Joystick Assembly.
Position Sensor Abnormal
1. Turn ignition switch and battery
Signal Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove right tim panels from
ROPS (WP 0494).
3. Disconnect connector CG-C14
(WP 0012, Figure 302) from
implement control joystick
connector (WP 0012, Figure 300).
4. Inspect implement control joystick
Joystick Assembly OK Proceed to
assembly for damage (WP 0503).
step 5.
Joystick Assembly Damaged
Replace implement control joystick
(WP 0503).
Proceed to Test Step 11.
5. Inspect connector CG-C14
Connector CG-C14 Damaged -
(WP 0012, Figure 302) for damage
Replace fuse panel wiring harness
IAW Electrical General
(WP 0515).
Maintenance Procedures
Proceed to Test Step 11.
(WP 0540).
No Problem Found - Proceed to Test
Step 3.
Test Step 3. Test Apron Position
Sensor Circuit, Battery + Circuit, and
Ground Circuit Function.
1. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
2. Using digital multimeter
Voltage 4.5 to 5.5 V Proceed to
(WP 0540), test for voltage
step 3.
between connector CG-C14
Voltage Less Than 4.5 V Proceed to
terminal 3 and terminal 2
Test Step 4.
(WP 0012, Figure 302).
3. Using digital multimeter
Voltage 18 to 25 V Proceed to Test
(WP 0540), test for voltage
Step 6.
between connector CG-C14
Voltage Less Than 18 V Proceed to
terminal 1 (WP 0012, Figure 302)
Test Step 10.
and ground.
0077-11