TM 5-3805-296-23-2
0077
Table 1. 1282 Apron Control Position Sensor Diagnostic Codes Continued.
077
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using digital multimeter
1282-03 Apron Lever
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Position Sensor Voltage
Replace main cab wiring harness
between connector CG-C1
Above Normal Continued
(WP 0505).
terminal 1 and terminal 67
Proceed to Test Step 9.
(WP 0012, Figure 283).
Resistance Greater Than 5.0 Ohms
Replace fuse panel wiring harness
(WP 0515).
Proceed to Test Step 9.
Test Step 9. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
1282-3 Apron Lever Position Sensor
diagnostic codes (WP 0008).
Voltage Above Normal Becomes
Inactive Proceed to step 4.
1282-3 Apron Lever Position Sensor
Voltage Above Normal Remains
Active Repeat troubleshooting from
the beginning.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. Install right trim panels on ROPS
(WP 0494).
6. Troubleshooting complete.
0077-6
