TM 5-3805-296-23-2
0077
Table 1. 1282 Apron Control Position Sensor Diagnostic Codes Continued.
077
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test Apron Position
1282-04 Apron Lever
Sensor Circuit Function.
Position Sensor Voltage
1. Disconnect connector CG-C14
Below Normal Continued
(WP 0012, Figure 302) from
implement control joystick
connector (WP 0012, Figure 300).
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
1282-3 Apron Lever Position Sensor
3. At MSD, check for active
Voltage Above Normal Becomes
diagnostic code 1282-4 Apron
Active Replace implement control
Lever Position Sensor Voltage
joystick (WP 0503).
Below Normal (WP 0008).
Proceed to Test Step 5.
1282-4 Apron Lever Position Sensor
Voltage Below Normal Remains
Active Proceed to Test Step 3.
Test Step 3. Test for Shorted Fuse
Panel Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
3. Using digital multimeter
Continuity Replace fuse panel wiring
(WP 0540), test for continuity
harness (WP 0515).
between connector CG-C1
Proceed to Test Step 5.
terminal 55 (WP 0012, Figure 283)
No Continuity Proceed to step 4.
and all other terminals
in connector CG-C1
(WP 0012, Figure 283).
4. Using digital multimeter
Continuity Replace fuse panel wiring
(WP 0540), test for continuity
harness (WP 0515).
between connector CG-C1
Proceed to Test Step 5.
terminal 55 (WP 0012, Figure 283)
No Continuity Proceed to Test
and ground.
Step 4.
0077-8
