TM 5-3805-296-23-2
0077
Table 1. 1282 Apron Control Position Sensor Diagnostic Codes Continued.
077
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Turn battery disconnect switch to
1282-08 Apron Lever
ON position and start engine
Position Sensor Abnormal
(TM 5-3805-296-10). Operate
Signal Continued
apron control lever through full
range of motion
(TM 5-3805-296-10).
5. At MSD, check for active
1282-8 Apron Lever Position Sensor
Abnormal Signal Becomes Inactive
diagnostic code 1282-8 Apron
Lever Position Sensor Abnormal
Troubleshooting complete. Proceed to
Signal (WP 0008).
step 6.
1282-8 Apron Lever Position Sensor
Abnormal Signal Remains Active
Replace implement control joystick
(WP 0503).
Proceed to Test Step 9.
6. Install right tim panels on ROPS
(WP 0494).
Test Step 9. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch to
ON position and start engine
(TM 5-3805-296-10). Operate
apron control lever through
full range of motion
(TM 5-3805-296-10).
3. At MSD, check for active
1282-8 Apron Lever Position Sensor
diagnostic codes (WP 0008).
Abnormal Signal Becomes Inactive
Proceed to step 4.
1282-8 Apron Lever Position Sensor
Abnormal Signal Remains Active
Replace transmission/chassis ECM
(WP 0495).
Proceed to Test Step 11.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. Install right tim panels on ROPS
(WP 0494).
6. Troubleshooting complete.
0077-14