TM 5-3805-296-23-2
0070
Table 1. 1275 Bowl Up Proportional Solenoid Diagnostic Codes Continued.
070
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using digital multimeter
1275-03 Bowl Up Solenoid
Continuity Replace implement wiring
(WP 0540), test for continuity
Voltage Above Normal
harness (WP 0349).
between connector F-C8
Continued
Proceed to Test Step 5.
terminal 6 (WP 0012, Figure 146)
No Continuity Proceed to Test
and all other terminals
Step 2.
in connector F-C8
(WP 0012, Figure 146).
Test Step 2. Test for Shorted Draft
Frame and Bowl Side Wiring
Harness.
1. Disconnect connector AE-C1
(WP 0012, Figure 144)
from connector E-C2
(WP 0012, Figure 143).
2. Using digital multimeter
Continuity Replace draft frame and
(WP 0540), test for continuity
bowl side wiring harness (WP 0348).
between connector AE-C1
Proceed to Test Step 5.
terminal 6 (WP 0012, Figure 144)
No Continuity Proceed to Test
and all other terminals
Step 3.
in connector AE-C1
(WP 0012, Figure 144).
Test Step 3. Test for Shorted Hitch
Wiring Harness.
1. Lower left frame access plate
(WP 0376).
2. Remove four bolts
(Figure 2, Item 1), washers
(Figure 2, Item 2), bushings
(Figure 2, Item 3), and splash
shield (Figure 2, Item 4) from
machine.
Figure 2. Splash Shield and Retaining Hardware.
0070