TM 5-3805-296-23-2
0069
Table 1. 0968 Transmission Hold Indicator Diagnostic Codes Continued.
069
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Turn battery disconnect switch and
0968-06 Gear Hold Lamp
ignition switch to ON position
Current Above Normal
(TM 5-3805-296-10).
Continued
5. At MSD, check for active
968-6 Gear Hold Lamp Current
Above Normal Becomes Inactive
diagnostic code 0968-06 Gear
Hold Lamp Current Above Normal
Replace gear hold LED (WP 0506).
(WP 0008).
Proceed to Test Step 4.
968-6 Gear Hold Lamp Current
Above Normal Remains Active
Proceed to Test Step 2.
Test Step 2. Test for Shorted Dash
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove throttle lock LED from
connector P-C29 and install LED
on connector P-C26. Connect
connector P-C26 on instrument
panel (WP 0506) (Figure 3).
3. Disconnect connector P-C1
(WP 0012, Figure 253)
from connector W-C7
(WP 0012, Figure 252).
4. Using digital multimeter
Continuity Replace dash wiring
(WP 0540), test for continuity
harness (WP 0510).
between connector P-C1
Proceed to Test Step 4.
terminal 23 (WP 0012, Figure 253)
No Continuity Proceed to step 5.
and all other terminals
in connector P-C1
(WP 0012, Figure 253).
5. Using digital multimeter
Continuity Replace dash wiring
(WP 0540), test for continuity
harness (WP 0510).
between connector P-C1
Proceed to Test Step 4.
terminal 23 (WP 0012, Figure 253)
No Continuity Proceed to Test
and ground.
Step 3.
Test Step 3. Test for Shorted Main
Cab Wiring Harness.
1. Disconnect connector W-C13
(WP 0012, Figure 89) from
transmission/chassis ECM.
2. Disconnect connector W-C12
(WP 0012, Figure 88) from
transmission/chassis ECM.
0069-10