TM 5-3805-296-23-2
0069
Table 1. 0968 Transmission Hold Indicator Diagnostic Codes Continued.
069
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 4. Verify Malfunction is
0968-05 Gear Hold Lamp
Resolved.
Current Below Normal
1. Ensure all harness connectors are
Continued
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
968-5 Gear Hold Lamp Current Below
diagnostic codes (WP 0008).
Normal Becomes Inactive Proceed
to step 4.
968-5 Gear Hold Lamp Current Below
Normal Remains Active Repeat
troubleshooting from the beginning.
4. Install instrument panel and
plenum (WP 0506).
5. Troubleshooting complete.
NOTE
0968-06 Gear Hold Lamp
Current Above Normal
Always inspect harness connectors that are involved in the circuit. Poor
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Abnormally High Current on XMSN Gear
Hold Lamp Circuit R764 During Lamp Test or Gear Hold Operation.
POSSIBLE CAUSE
Gear Hold LED Shorted.
Dash Wiring Harness Shorted.
Main Cab Wiring Harness Shorted.
Transmission/Chassis ECM.
0069-8
