TM 5-3805-296-23-2
0070
Table 1. 1275 Bowl Up Proportional Solenoid Diagnostic Codes Continued.
070
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector F-C4
1275-05 Bowl Up Solenoid
(WP 0012, Figure 154) from
Current Below Normal
bowl up solenoid connector
Continued
(WP 0012, Figure 153).
4. Connect jumper wire between
terminal 1 and terminal 2
of connector F-C4
(WP 0012, Figure 154).
5. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
6. At MSD, check for active
1275-6 Bowl Up Solenoid Current
Above Normal Becomes Active
diagnostic code 1275-5 Bowl Up
Replace bowl up solenoid (WP 0436).
Solenoid Current Below Normal
Proceed to Test Step 6.
(WP 0008).
1275-5 Bowl Up Solenoid Current
Below Normal Remains Active
Proceed to Test Step 2.
Test Step 2. Test Implement Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Do not remove jumper wire from
terminal 1 and terminal 2
of connector F-C4
(WP 0012, Figure 154).
3. Disconnect connector F-C8
(WP 0012, Figure 146)
from connector AE-C5
(WP 0012, Figure 145).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 3.
between connector F-C8
Resistance Greater Than 5.0 Ohms
terminal 5 and terminal 6
Replace implement wiring harness
(WP 0012, Figure 146).
(WP 0349).
Proceed to Test Step 6.
Test Step 3. Test Draft Frame and
Bowl Side Wiring Harness for High
Resistance or Open.
1. Remove jumper wire from terminal
1 and terminal 2 of connector F-C4
(WP 0012, Figure 154).
2. Connect jumper wire between
terminal 5 and terminal 6
of connector AE-C5
(WP 0012, Figure 145).
0070-8
