TM 5-3805-296-23-2
0070
Table 1. 1275 Bowl Up Proportional Solenoid Diagnostic Codes Continued.
070
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Turn ignition switch and battery
1275-05 Bowl Up Solenoid
disconnect switch to OFF position
Current Below Normal
(TM 5-3805-296-10).
Continued
5. If removed, install splash shield
(Figure 4, Item 4), four bushings
(Figure 4, Item 3), washers
(Figure 4, Item 2), and bolts
(Figure 4, Item 1) on machine.
6. If lowered, install left frame access
plate (WP 0376).
7. Install front cover
(Figure 3, Item 3), four washers
(Figure 3, Item 1), and bolts
(Figure 3, Item 2) on machine.
8. Troubleshooting complete.
NOTE
1275-06 Bowl Up Solenoid
Current Above Normal
Always inspect harness connectors that are involved in the circuit. Poor
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Above Normal Current on Bowl Up
Solenoid Circuit R715.
POSSIBLE CAUSE
Implement Wiring Harness Shorted.
Draft Frame and Bowl Side Wiring Harness Shorted.
Hitch Wiring Harness Shorted.
Main Cab Wiring Harness Shorted.
Bowl Up Solenoid.
Transmission/Chassis ECM.
0070-11
