TM 5-3805-296-23-1
0041
Table 1. 2417 Start Aid Diagnostic Codes Continued.
041
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
2417-06 Ether Injection
7. Using digital multimeter
Continuity Replace engine interface
Control Solenoid Current
(WP 0540), test for continuity
wiring harness (WP 0211). Replace
Above Normal Continued
between connector CL-C1
basic engine wiring harness (WP 0251).
terminal 20 (WP 0012, Figure 45)
Proceed to Test Step 6.
and all terminals in connector
No Continuity Proceed to step 8.
CM-C1 (WP 0012, Figure 30).
8. Using digital multimeter
Continuity Replace engine interface
(WP 0540), test for continuity
wiring harness (WP 0211).
between connector CL-C1
Proceed to Test Step 6.
terminal 20 (WP 0012, Figure 45)
No Continuity Replace engine ECM
and ground.
(WP 0252).
Proceed to Test Step 6.
Test Step 6. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
2417-6 Ether Injection Control
diagnostic codes (WP 0008).
Solenoid Current Above Normal
Becomes Inactive Proceed to step 4.
2417-6 Ether Injection Control
Solenoid Current Above Normal
Remains Active Repeat
troubleshooting from the beginning.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. If removed, install splash shield
(Figure 4, Item 4), four bushings
(Figure 4, Item 3), washers
(Figure 4, Item 2), and bolts
(Figure 4, Item 1) on machine.
0041-12