TM 5-3805-296-23-1
0026
Table 1. 0174 Fuel Temperature Sensor Diagnostic Codes Continued.
026
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test for Shorted Fuel
0174-04 Fuel Temperature
Filter Wiring Harness.
Sensor Voltage Below
1. Turn ignition switch and battery
Normal Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector AW-C4
(WP 0012, Figure 34)
from connector CL-C9
(WP 0012, Figure 33).
3. Using digital multimeter
Continuity Replace fuel filter wiring
(WP 0540), test for continuity
harness (0171).
between connector AW-C4
Proceed to Test Step 5.
terminal 1 (WP 0012, Figure 34)
No Continuity Proceed to step 4.
and all other terminals
in connector AW-C4
(WP 0012, Figure 34).
4. Using digital multimeter
Continuity Replace fuel filter wiring
(WP 0540), test for continuity
harness (0171).
between connector AW-C4
Proceed to Test Step 5.
terminal 1 (WP 0012, Figure 34)
No Continuity Proceed to
and ground.
Test Step 3.
Test Step 3. Test for Shorted Engine
Interface Wiring Harness.
1. Lower left frame access plate
(WP 0376).
2. Remove four bolts
(Figure 4, Item 1), washers
(Figure 4, Item 2), bushings
(Figure 4, Item 3), and splash
shield (Figure 4, Item 4) from
machine.
Figure 4. Splash Shield and Retaining Hardware.
0026