TM 5-3805-296-23-1
0026
Table 1. 0174 Fuel Temperature Sensor Diagnostic Codes Continued.
026
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector CL-C10
0174-04 Fuel Temperature
(WP 0012, Figure 32) from
Sensor Voltage Below
connector CM-C11 (WP 0012,
Normal Continued
Figure 31).
4. Using digital multimeter
Continuity Replace engine interface
(WP 0540), test for continuity
wiring harness (WP 0211).
between connector CL-C9
Proceed to Test Step 5.
terminal 1 (WP 0012, Figure 33)
No Continuity Proceed to step 5.
and all other terminals
in connector CL-C9
(WP 0012, Figure 33).
5. Using digital multimeter
Continuity Replace engine interface
(WP 0540), test for continuity
wiring harness (WP 0211).
between connector CL-C9
Proceed to Test Step 5.
terminal 1 (WP 0012, Figure 33)
No Continuity Proceed to
and ground.
Test Step 4.
Test Step 4. Test for Shorted Basic
Engine Wiring Harness.
1. Disconnect connector CL-C1
(WP 0012, Figure 45) from engine
ECM.
2. Disconnect connector CM-C1
(WP 0012, Figure 30) from engine
ECM.
3. Using digital multimeter
Continuity Replace basic engine
(WP 0540), test for continuity
wiring harness (WP 0251).
between connector CM-C1
Proceed to Test Step 5.
terminal 62 (WP 0012, Figure 30)
No Continuity Proceed to step 4.
and all other terminals
in connector CM-C1
(WP 0012, Figure 30).
4. Using digital multimeter
Continuity Replace basic engine
(WP 0540), test for continuity
wiring harness (WP 0251). Replace
between connector CM-C1
engine interface wiring harness
terminal 62 (WP 0012, Figure 30)
(WP 0211).
and all terminals in connector
Proceed to Test Step 5.
CL-C1 (WP 0012, Figure 45).
No Continuity Proceed to step 5.
5. Using digital multimeter
Continuity Replace basic engine
(WP 0540), test for continuity
wiring harness (WP 0251).
between connector CM-C1
Proceed to Test Step 5.
terminal 62 (WP 0012, Figure 30)
No Continuity Replace engine ECM
and ground.
(WP 0252).
Proceed to Test Step 5.
0026-11