TM 5-3805-296-23-1
0023
Table 1. 0110 Engine Coolant Temperature Sensor Diagnostic Codes Continued.
023
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test for Shorted Basic
0110-04 Engine Coolant
Engine Wiring Harness.
Temperature Sensor Voltage
1. Turn ignition switch and battery
Below Normal Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Lower left frame access plate
(WP 0376).
3. Remove four bolts
(Figure 3, Item 1), washers
(Figure 3, Item 2), bushings
(Figure 3, Item 3), and splash
shield (Figure 3, Item 4) from
machine.
Figure 3. Splash Shield and Retaining Hardware.
0023
4. Disconnect connector CL-C1
(WP 0012, Figure 45) from engine
ECM.
5. Disconnect connector CM-C1
(WP 0012, Figure 30) from engine
ECM.
6. Using digital multimeter
Continuity Replace basic engine
(WP 0540), test for continuity
wiring harness (WP 0251).
between connector CM-C1
Proceed to Test Step 3.
terminal 13 (WP 0012, Figure 30)
No Continuity Proceed to step 7.
and all other terminals
in connector CM-C1
(WP 0012, Figure 30).
7. Using digital multimeter
Continuity Replace basic engine
(WP 0540), test for continuity
wiring harness (WP 0251). Replace
between connector CM-C1
engine interface wiring harness
terminal 13 (WP 0012, Figure 30)
(WP 0211).
and all terminals in connector
Proceed to Test Step 3.
CL-C1 (WP 0012, Figure 45).
No Continuity Proceed to step 8.