12
13
CAMSHAFT
BUSHING
TOOL
11
2
2
11
TM 9-4940-568-34
7-55
NOTE
When the tappet is dropped into
the plastic trough, most of the
time it will fall over. However, if
it doesn’t, gently shake the plastic
trough just enough to allow the
tappet to fall over before
removing. When removing
tappets from number four
cylinder ensure tappet does not
fall off end of trough.
(12)
Carefully pull the plastic trough (11) and
tappet (2) from cam bore and remove
tappet.
(13)
Repeat Steps (9) through (11) until all
tappets (2) are removed.
(14)
Using camshaft bushing tool, remove
camshaft bushing (12) from the No. 1 bore.
(15)
Mark the camshaft bushing (12) and
cylinder block (13) to align the lubricating
oil hole in the cylinder block with the
lubricating oil hole in the bushing.
