TM 9-4940-568-34
6-37
(17) Remove and discard preformed packing
(23) from cover (4).
(18) Remove retaining ring (24) and bearing
(25) from cover (4).
b. Cleaning/Inspection
(1) Clean all parts.
NOTE
Replace any part that fails visual
inspection or size measurement
requirements.
(2) Inspect all parts for pitting, corrosion,
scoring, damaged splines, damaged
teeth, or indications of binding.
(3) Check eight stators (10) for wear,
minimum thickness 0.065 in.
(0.162 cm).
(4) Check seven discs (11) for wear,
minimum thickness 0.058 in.
(0.144 cm).
(5) Check six springs (22) for length,
minimum length 1.5 in. (3.8 cm).
(6) Inspect all other parts. Replace all parts
failing inspection.
c. Assembly
NOTE
Lubricate all preformed packings
and seal with clean hydraulic oil.
(1) Install bearing (25) in cover (4).
(2) Install retaining ring (24) and preformed
packing (23) on cover (4).
