TM 9-4940-568-34
6-32
6-7.
GEAR SET REPAIR (Continued)
b.
Cleaning/Inspection
(1) Clean all parts.
(2) Inspect all parts for burrs, cracks,
crossed, or peened threads.
(3) Repair or replace all parts failing
inspection.
c.
Assembly
(1) Install bearing (36) in LH drum end (33).
(2) Install seal (35) in LH drum end (33).
(3) Install preformed packing (34) on LH
drum end (33).
(4) Apply sealing compound to threads of
eight screws (31) and silicone sealant to
mating surface of ring gear (5).
(5) Position LH drum end (33) on ring gear
(5) with eight washers (32) and screws
(31).
(6) Tighten screws (31) to 16 lb-ft (22 N.m).
NOTE
All three gears are assembled
the same way. Only one shown.
(7) Install two roller sets (28) and separator
(29) in gear (27).
(8) Install gear (27) and two washers (26) in
carrier (15) with pin (25).
WARNING
Use care when installing retain-
ing rings. Retaining rings are un-
der tension and can act as pro-
jectiles when released. Failure
to comply may result in injury to
personnel.
(9) Install retaining ring (24) on pin (25).
(10) Perform steps (7 through 9) on
remaining gears (10).
(11) Install washer (30) in carrier (15).
