TM 9-4940-568-34
6-16
6-4.
SWING DRIVE ORBIT MOTOR REPAIR (Continued)
(3) Remove seal (5) from end cap (4).
Discard seal.
CAUTION
Geroter is a two piece assembly.
Use care when removing geroter.
Do not allow parts to separate.
Failure to comply may result in
damage to equipment.
(4) Remove geroter (6) from motor housing
(1).
(5) Remove seal (7) from geroter (6).
Discard seal.
(6) Remove spacer plate (8) from motor
housing (1).
(7) Remove drive gear shaft (9) from motor
housing (1).
(8) Remove preformed packing (10) from
motor housing (1). Discard preformed
packing.
(9) Remove output shaft (2) from motor
housing (1).
(10) Remove needle thrust bearing (11) from
motor housing (1).
(11) Reposition motor housing (1) in vise
with flange (12) facing up.
(12) Heat up four screws (13) to loosen
sealing compound.
(13) Remove four screws (13) from motor
housing flange (12).
(14) Remove motor housing flange (12) from
motor housing (1).
NOTE
Note position of seals prior to
removal.
(15) Remove seal (14), seal (15), seal (16),
and backup washer (17) from motor
housing flange (12). Discard seals and
backup washer.