2
6
13
14
9
11
12
2
5
1
3
10
10
TM 9-4940-568-34
5-55
NOTE
Do not exceed 1/2 revolution of
each nut to prevent wear sleeve
binding and irregular stretch.
(3)
Position chamfered end of wear sleeve (9)
on end of crankshaft (12). Position
counterbore end of wear sleeve installation
tool (11) over threaded studs and align with
wear sleeve, perpendicular to end of
crankshaft. Install two washers (13) and
nuts (14) on threaded studs (10).
Alternately tighten nuts (14) until
installation tool contacts end of crankshaft.
(4)
Remove two nuts (14), washers (13), wear
sleeve installation tool (11) and two
threaded studs (10) from crankshaft (12).
(5)
Align rear cover (3) even with both sides of
oil pan (2).
(6)
Install four oil pan mounting screws (1) on
oil pan (2). Tighten screws to 18 lb-in (2
N.m).
(7)
Tighten six screws (5) on rear cover (3) to
80 lb-in (9 N.m).
NOTE
Ensure gasket excess does not
enter engine.
(8)
Trim gasket (6) even with oil pan (2)
mounting surface.
d.
Follow-On Maintenance:
Install flywheel, (Para 5-11).
Install engine, (Para 5-4).
END OF TASK
