TM 9-2330-238-14
5-22. LEFT REAR DOOR LOCK REPLACEMENT
(M313, EARLY MODEL).
This Task Covers:
a.
Removal
c.
Installation
b.
Cleaning
and Inspection
Initial Setup:
Materials/Parts:
Tools/Test Equipment:
l Dry cleaning
solvent (Item 14, Appendix
E)
l General mechanic’s
tool kit
l Two cotter pins
1.
2.
3.
4.
5.
Remove
two
cotter
pins
(11) and
disconnect
upper and lower locking
rod-s (7 and 9) from case
assembly
(8). Discard cotter pins.
Remove two screws (1) with assembled
washers
from upper and lower locking
rods (7 and 9) and
locking bolts (4 and 10). Remove locking rods and
bolts.
Drive out grooved
headless
straight pin (13) from
door handle (12). Remove door handle from case
assembly
(8).
Remove twelve
screws
(14), case assembly
(8),
and two guide brackets
(5) from door (6).
Remove six screws (2) and three catch strikes (3)
from door (6).
WARNING
Dry cleaning solvent, P-D-680,
is toxic and flammable.
Always wear protective goggles
and gloves, and use only in a well-ventilated
area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open frame or excessive heat.
The solvent’s flash point is 100°F-138°F
(38°C-59°C).
if you become
dizzy while
using cleaning solvent, Immediately
get fresh air and medical help. if solvent contacts
eyes, immediately
wash your eyes and get medical aid.
1.
Clean all parts with dry cleaning
solvent and dry thoroughly.
5-64
TA702101
