TM 9-2330-238-14
5-19. RIGHT REAR DOOR AND SIDE DOOR LOCKS REPLACEMENT
(M313, LATE MODEL)
(Con’t).
WARNING
Dry cleaning solvent, P-D-680,
is toxic and flammable.
Always wear protective goggles
and gloves, and use only in a well-ventilated
area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open frame or excessive
heat.
The solvent’s
flash point is 100°F-138°F
(38°C-59°C).
If you become
dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If solvent contacts
eyes, immediately
wash your eyes and get medical aid.
1.
Clean all parts with dry cleaning
solvent and dry thoroughly.
2.
Inspect latch and door bolts for ease of operation.
3.
Inspect connecting
links for cracks, bends, or breaks. Straighten
any minor bends.
4.
Replace
any defective
parts.
1.
From outside of door
screws (9).
(10), position
new gasket (7) and outer door handle (8) in place on door and install three
2.
From inside of door (10), position
latch (6) and connecting
links (5 and 12) in place and install four screws (3).
3.
Position exit bolt (11) and flush bolt (4) in place on door (10) and install eight screws (3).
4.
Install connecting
links (5 and 12) in place on exit bolt (11) and flush bolt (4) and secure with two capscrews (14)
and new Iockwashers
(13).
5.
Position door handle (1) in place on shaft with holes alined and install grooved
headless
pin (2).
6.
Lubricate
latch (6) and bolts (4 and 11) in accordance
with Lubrication
Instructions
(Chapter 3, Section I).
5-59
