TM 9-2330-238-14
5-13. LANDING GEAR LEG ASSEMBLY REPAIR (EARLY MODEL) (Con’t).
9.
10.
11.
12.
13.
Start drive shaft (11) in opening
on top of upper leg assembly
(34) with end of drive shaft that contains three
holes facing mounting
side of leg assembly.
Install washer (6) and bevel gear (35) over woodruff key (36) on drive shaft (11), then slide drive shaft in place in
upper leg assembly
(34) and secure with two new spring pins (12).
Install intermediate
drive shaft (23) on drive shaft (11) with capscrew
(24) and new self-locking
nut (22).
Lubricate
bevel gears (7 and 35) in accordance
with Lubrication
Instructions
(Chapter 3, Section I).
Position new gasket (3) and access cover (2) in place on top of upper leg assembly
(34) and install four screws
(1).
TA702081
5-37
