TM 54930-244-14
b.
Assembly.
(1)
Place sleeve (19) through hole (17) in crankcase (5). Place flat washer (7) on sleeve (19). Place shaft (15) in
sleeve (19) and drive sleeve (19) in crankcase (5) using drift punch through hole (17).
(2)
Remove shaft (15) and washer (7) from sleeve (19).
(3)
Place lever (18) into crankcase (5) and place block of wood (21) under lever (18).
(4)
Place shaft (15) through hole (17) and lever (18). Place drift punch through hole (17) and drive shaft (15) into
lever (18).
(5)
Place bracket (14) in crankcase (5) and over lower end of shaft (15). Tighten screw (13).
(6)
Install spring (12) and adjuster (11) in crankcase (5). Install washer (10) and nut (9) on adjuster (11).
(7)
Install governor (para. 6-5).
(8)
Adjust governor linkage (para. 6-7).
(9)
Install plunger (8) to crankcase (5).
(10)
Install washer (7) and breather (6) to crankcase (5).
(11)
Install flap (4), new packing (3), cover (2), and screw (1) to crankcase (5).
(12)
Install camshaft gear (para. 6-4).
(13)
Install fuel injection pump (para. 5-10.d.).
(14)
Install fuel lift pump (para. 5-10.f.).
(15)
Perform engine running-in (para. 6-11).
6-36
