TM 5-4930-244-14
6-7. GOVERNOR LINKAGE - REPAIR.
This Task Covers:
a.
Disassembly
b.
Assembly
Initial Setup:
Tools and Test Equipment Required
Tool Kit, General Mechanic's: Automotive (Appendix B, Section III, Item 1).
Chemical and Oil Protective Gloves (Appendix B, Section III, Item 8).
Industrial Goggles (Appendix B, Section III, Item 9).
Materials/Parts Required
Dry Cleaning Solvent (Appendix E, Section II, Item 3).
Wiping Rags (Appendix E, Section II, Item 1)
Wood Block (Appendix E, Section II, Item 25)
Equipment Condition
Fuel Lift Pump Removed (para 5-10.f.)
Fuel Injection Pump Removed (para 5-10.d)
Camshaft Removed (para. 6-4, steps 1 thru 11).
Governor Removed (para 6-5).
Personnel Required
2
a. Disassembly. (Refer to Figure 6-6).
(1)
Remove screw (1), breather assembly cover (2), preformed packing (3), and breather flap (4) from crankcase (5)
(2)
Unscrew breather (6) from crankcase (5). Remove breather (6) and washer (7) from crankcase (5).
(3)
Remove plunger (8) from crankcase (5).
(4)
Remove nut (9) and washer (10) from speed adjuster (11).
(5)
Remove adjuster (11) and speeder spring (12) from crankcase (5).
(6)
Loosen socket head screw (13) and remove bracket (14) from shaft (15).
(7)
Lift shaft (15) and place a block of wood (16) under shaft (15). Place hollow tubular drift through hole (17) over
shaft (15) on top of operating lever (18) Drive lever (18) off shaft (15). Remove wood block (16)
(8)
Remove lever (18) and shaft (15) from crankcase (5).
(9)
Remove sleeve (19) from crankcase (5)
6-33
