TM 5-4930-244-14
6-8. GOVERNOR LINKAGE ADJUSTMENT.
This Task Covers:
a.
Adjust
Initial Setup:
Tools and Test Equipment Required
Tool Kit, General Mechanic's: Automotive (Appendix B, Section III, Item 1)
Materials/Parts Required
Wiping Rags (Appendix E, Section II, Item 1).
Equipment Condition
Camshaft Removed (para. 6-4).
a. Adjust. (Refer to Figure 6-7).
NOTE
Engine is sitting on flywheel end
(1)
Install fuel injection pump (Reference para 5-10.d.).
(2)
Set Governor Linkage
(a)
Loosen socket head screw (1).
(b)
Check that bracket (2) is hard against governor (3) with sliding cones (4) and governor (3) together.
(c)
If bracket (2) is not hard against governor (3), adjust speed adjuster (5) against spring (6) to position cones
(4) and governor (3) together.
(d)
Push fuel injector pump operating lever (7) toward flywheel to maximum position.
(e)
Loosen setscrew (8) and move bracket (2) up and down shaft (9).
(f)
Insert feeler gage at point A Push down on lever (7) while pushing up on bracket (2).
(g)
Set distance between lever (7) and top of governor shaft bushing (10) to 0 010 inch (0 25 mm).
(h)
Tighten screw (1) to ensure feeler gage bracket distance is secure.
(i)
Tighten setscrew (8) on bracket (2).
(3)
Remove fuel Injection pump ( para 5-10 d ).
(4)
Install camshaft (para 6-4).
6-37
