TM 5-4930-244-14
WARNING
·
Dry cleaning solvent is flammable. Do not use near open flame or non-
ventilated places. Keep away from open flames or sparks Avoid Inhaling
solvent fumes Avoid contact with skin. Flash point of solvent is 100° F to 138°
F (38° C to 59° C).
·
Compressed air used for cleaning purposes will not exceed 30 psi. Use only
with
effective
chip-guarding
and
personal
protective
equipment
(goggles/faceshield, gloves, etc ).
(7)
Using dry cleaning solvent and compressed air, clean all parts.
(8)
Check the governor balls and sliding cone for wear of damage.
(9)
Hold the assembly horizontal, by the housing, in one hand and spin the gear (14) with the other hand As the gear
revolves, the governor cone assembly should be forced towards the retaining ring If there are any tight spots or
damage, the complete governor assembly should be replaced.
b. Installation.
(1)
Apply sealing compound to three screws (16) Install screws (16) and governor (17) to crankcase (3).
(2)
Install new key (15) in shaft (13).
(3)
Install gear (14) and new nut (12) to governor (17).
(4)
Apply sealing compound to eight screws (4, 5).
(5)
Install seven screws (5), new gasket (6), and cover (1) to crankcase (3).
(6)
Install screw (4) to crankcase (3).
(7)
Torque screws (4, 5) to 9 lb-ft (12 Nm).
6-31
