TM 5-3825-230-14&P
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles, face mask, and
gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and
don't breathe vapor. Do not use near open flame or excessive heat. The flashpoint for type I dry
cleaning solvent is 100°F (38°C) and for type II is 140°F (60 °C). If you become dizzy while using
cleaning solvent, get fresh air immediately and get medial aid. If contact with eyes is made, flush
eyes with water and get medical aid immediately.
NOTES:
1.
Scrape old foam pads from saddle with scraper and clean affected areas with dry cleaning solvent P-D-
680.
2.
Remove edge trim from the saddle and clean affected area with dry cleaning solvent P-D-680.
3.
Cut foam pads A and B and/or edge trim to lengths specified In table G-6.
4.
Install foam pads A and B and/or edge trim to saddle with self-adhesive side facing down.
Figure G-4. Saddle Trim and Pads
G-7
