TM 5-3825-230-14&P G-4. ELECTRICAL GROUND AND JUMPER WIRES FABRICATION. There are six ground and jumper wires in the electrical system.  Locations are shown in the RPSTL, figures 32, 34, and 35.  Refer to paragraph 4-83 for terminal or connector installation. Table G-2.  Ground and Jumper Wires Cutoff Length Wire Part Number Bulk Wire Part Number Inches (mm) Wire Gauge WG-16-0-6IN WG-16-0-1000 6 (152) 16 ga WG-16-0-8IN WG-16-0-1000 8 (203) 16 ga WG-16-0-12IN WG-16-0-1000 12 (305) 16 ga 703-92132 WG-10-0-1000 9 (228) 10 ga 703-92096 WB-4-0-500 10 (254) 4 ga WG-16-0-6IN WG-16-0-1000 6 (152) 16 ga G-5. CONDUIT FABRICATION. Conduit for the broom hood wiring harness is fabricated from bulk PVC pipe stock, P/N A52AE12.  Cut conduit using a fine-toothed hacksaw or suitable cutting device.  Drill endcaps with a drill and 1/2" drill bit.  Coupling, P/N E940D can be used for repair of damaged conduit.  Refer to paragraph 4-78 for installation instructions. Table G-3.  Conduit Fabrication PVC Bulk PVC Cutoff Length Part Number Part Number Inches (mm) Quantity Fitting A Fitting B 402-92109 A52AE12 2 (51) 1 401-005 N/A 402-92111 A52AE12 48.5 (1221) 2 401-005 406-005E 402-92110 A52AE12 16 (406) 2 406-005E 447-005 G-2