TM 5-3825-230-14&P
G-7.
STUD LINK CHAIN FABRICATION.
One stud link chain is located on the main frame assembly.
NOTES:
1.
Obtain enough bulk chain, P/N 3607T21, to fabricate stud link chain to desired length.
2.
Use a fine-toothed hacksaw or suitable cutting device and cut chain.
3.
Install retaining ring, P/N 29-10, and cotter pin, P/N MS24665-495, on chain.
Figure G-2. Stud Link Chain
G-8.
HYDRAULIC HOSE FABRICATION.
The following hydraulic hoses are cut from bulk hose using a fine-toothed hacksaw or suitable cutting device, and are
clamped on to the hydraulic fittings. Refer to paragraph 4-105 for installation instructions.
Table G-4. Hydraulic Hoses
Hose Assembly
Bulk Hose
Cutoff Length
Part Number
Part Number
Inches (mm)
204-85611
2556-12
11(279)
204-85730
U216-6
30 (762)
204-85690
2556-12
90 (2286)
G-4
