TM 5-3825-230-14&P
Section II. DIRECT SUPPORT MAINTENANCE MANUFACTURED ITEMS
G-13.
THROTTLE CONTROL LOCKWIRE FABRICATION.
Lockwire for the throttle control lever assembly is fabricated from bulk wire stock, P/N MS20995C20. It is fabricated by
cutting a 12 in. (305 mm) length of the bulk wire with wire cutters. Refer to paragraph 5-28 for installation instructions.
G-14.
HYDRAULIC HOSE FABRICATION.
The following hydraulic hoses are cut from bulk stock. Refer to paragraph 4-105 for installation instructions. Table G-7
lists the hoses and adapters.
Table G-7. Hydraulic Hose Assembly Components
Hose Assembly
Bulk Hose
Cutoff Length
Part Number
Part Number
Inches (mm)
Adapter A
Adapter B
204-85451
J412
51(1295)
HL12-12NJ
HL12-12NJ
204-85041
SAE100R1TY-ATSZ4
41(1041)
HA04-04MB
HG04-04NJ
204-85493
J412
93(2362)
10655-12-12
10655-12-12
NOTES:
1.
Obtain all components required to fabricate desired hose assembly (table G-7).
2.
Use a fine-toothed hacksaw or suitable cutting device and cut hose to desired length.
3.
Slide adapter A on hose and crimp as necessary.
4.
Slide adapter B on hose and crimp as necessary.
5.
Prior to installation, test hose and adapter assembly to 2, 000 psi (13, 800 kPa) using methods found in
TM 9-4940-468-14, Tool Outfit Hydraulic System Test and Repair.
Figure G-5. Hydraulic Hose Assembly Components
G-8
