TM 5-3825-230-14&P
5-41. HYDRAULIC CONTROL VALVE REPAIR (CONT).
(f)
Install two O-rings (24), valve spool (17), and retainer (23).
WARNING
Steel balls and springs in detent retainer are under extreme pressure and may come out with
velocity. Wear eye protection during this procedure.
(g)
Install two springs (22) and four steel balls (21) in detent retainer (18).
(h)
Install detent retainer (18) in detent sleeve (20) making sure threaded part of retainer protrudes on
other side of sleeve. Install lockwasher (19) on retainer.
WARNING
Adhesives, solvents and sealing compounds can burn easily, can give off harmful vapors and are
harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in well-
ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash
immediately with soap and water.
NOTE
The narrow end of detent sleeve should be towards valve body.
(i)
Apply thread locking compound to threads of detent retainer (18) and assemble detent retainer,
lockwasher (19), and detent retainer sleeve (20) on valve spool (17) as one piece.
(j)
Install three washers (16).
5-108
